Solenoid Driver Module - Worldwide Delivery of Electromechanical Components from Los Angeles, California


Solenoids	Electromagnets	Electronics	Electric Cylinders	Magnets	Wire	Tubing	Springs

Search

only one keyword search term per box

Categories

Home

Solenoid Driver Module
item #: ELSOSDM840

Unit Price:
1-4 pieces:	$153.98
5-9 pieces:	$135.07
10-24 pieces:	$120.46
25-49 pieces:	$108.64
50-99 pieces:	$98.69
Prices for larger quantities may be obtained by contacting us or by clicking the RFQ below.
OEM quantities, more than 100 units or special instructions:

Special Comments

Quantity adjustment on next page

One method of consuming less energy is to apply a voltage to the solenoid coil to provide the necessary force to pull the plunger in, then, when seated, drop the voltage down to a level sufficient to maintain the plunger in a seated position.

The Pick and Hold Module is designed to apply an initial higher voltage to the coil for a pre-determined period of time and then drop the voltage to a pre-determined percentage of the initial value through pulse width modulation to avoid over heating the solenoid coil

The above voltage sequence will be applied to the coil when a voltage (2 to 40 VDC) is applied to the trigger. The trigger voltage can be a secondary voltage (external trigger) or the same voltage used for input voltage (internal trigger).

This is particularly useful when a solenoid requiring a relatively large amount of power needs to be turned on and off with a low power trigger voltage such as a TTL compatible signal.

Parameter	Min	Typical	Max	Units
Supply Input Voltage	8		40	VDC
Peak Current			20	A
RMS Current			3	A
Command (Trigger) Range	2		40	VDC
Command Input Resistance	50			KOhms
Operating Temperature	0		80	Deg C
Storage Temperature	-40		125	Deg C
PWM Frequency		20		KHz
Peak Time		100*		mSec
Holding Voltage to Supply Voltage Ratio		30**		%

* Peak time can be made longer in factory on special orders.

** Holding voltage is preset in factory at 30% of input voltage.
This value can be adjusted with the potentiometer on the board.

Quantity adjustment on next page